Skip to main content

Motor Winding


LAKSHMI 0.5HP


Centrifugal regenerative pump
Monobloc
1 PH, 240V, 50Hz
Duty S1, Class’B’, CSR tech type
HP               0.5
Capacitor   12.5mfd
Head           18m.
Current       3A
Speed         2850rpm
Size            25*25mm





WINDING
Starting winding                                                                               Runningwinding
27 swg, 350gm,                                                                                          24 swg, 450gm,
1-8            50                                                                                    1-6               40
1-10          110                                                                                  1-8                80
1-12          110                                                                                  1-10              80
                                                                                                         1-12              80
Labels:

Comments

Post a Comment

Popular posts from this blog

Fleming's left hand rule

Fleming's left hand rule The direction of force produced on a current-carrying cunductor placed in magnetic field can be determined by this rule. as shown in photo hold the thumb,forefinger and middle finger of the left hand mutually at right angles to each other., such that the forefinger is in the direction of current flow in the cunductor; then the thumb indicates the direction of motion of the conductor.
Post a Comment
Read more

Mains LED light

MAINS NIGHT LIGHT This is a LED circuit this can be operated from main supply. The circuit illuminates a column of 10 white LEDs. The 10u prevents flicker and the 100R also reduces flicker.
Post a Comment
Read more

Battery monitor LED

BATTERY MONITOR This circuit makes it possible to monitor the charging process of a battery. After constructing the circuit, final adjustments are simple and the only thing needed is a digital voltmeter for the necessary accuracy. Connect an input voltage of 12.65 volt between the positive and negative connections of the circuit and adjust the VR1 (10K trimmer) until Led 10 lights up. Lower the voltage and in sequence all other LEDs will light up. Check that Led 1 lights up at approximately 11.85 volts. At 12.65 volt and higher the battery is fully charged, and at 11.85 is considered to be at its lowest state. LED 8, 9 and 10 indicate the battery capacity is more than 50%, LED 4 to LED 7 indicate a capacity of 30% - 50% and LED 1 to LED 3 indicate less that 30%. This circuit, with the components shown, uses less than 10mA. Of course you can adapt it to your own needs by making small modifications. This circuit is set for DOT mode, meaning only one LED at a time will be lit. If you ...
Post a Comment
Read more